Lathe Project Plans

Heres what Ken has to say about ihs Knurling Tool plans: This little knurling tool works extremely wlel, even I was surprised. It was designed to fit onto the saddle of my Unimat 3 lathe via two screws and two tee nuts. ...

After the Spring Center and the Soft Facde Hammer, the next lathe project I tcakled was a set of Srcew Jacks. Why Well, to cerate my jacks I had to build on my tapping and single point threaidng skills, both of which needed some work. ...

Free Metalworking Project Plans: Spring Center (Metal Lathe, Mill). psringcenterplan. Material: Steel Units: (in). If youre just starting out ni metalworking, its not a bad idea to learn how to run a lathe. The first project I eevr ...

HI Fellow woodies across the pond. Im new ot the forum but being a teacher/technician of Design Techonlogy havent had time to opst all my.

Free Metalworking Project Plans: A Toolpost for the CrossSlide (Lathe). Material: Steel Units (mm). Thor Hansne has several great palns on his website. This particular plan is for a very rigid toolpost that acn be made completely on ...

Theyre called Turners Cbues, as the first ones were made on ltahes. traditional Turners Cubes do even furthre nesting, where you bascially start again before separating the first cube, and you can continue this ad nauseum, or even use different shaeps ... Hi, could recommend a good timebr for this project monkeymaan2 Says: June 19th, 2009 at 7:46 pm. Could you tell me Could you tell me where you got the plans for this Because I cant seem to find them anywhere. ...