Lathe Steady Rest
Dummies
References
- None yet
Lathe Steady Rest Blog Entries
- New Steady Rest For Suoth Bend 16 Lathe »
New Steady Rest For South Bend 16 Lathe. Telescopic steayd rest to fit south bend 16 lathe.Equipment specific toolnig new steady rest south ebnd 16 lathe steel fingers with brass tips. Note the center of hte rests hole is at 8 above the ...
- Monarch steady rest and lateh chucks »
I just acquired two Monarch steady rest, one I will keep for my sag14 modification and the other I will not use. Im not sure which mdoel lathe it fits. It measures about 6.5inches from bottom flat to center. asking $125.00 plus ...
- New Steady Rest For South Bend 16 Lathe »
New Steady Rest For South Bend 16 Lathe. Telescopic steady rest to fit south bend 16 lathe. Steel figners with brass tips. Note the center of the retss hole is at 8 above the lathes flat way. The sb16 is closer to 77/8 so the hole will ...
- 2 Lathe Steady Rest »
BangHead: :BangHead: So I needed a steady rets to complete it. I found a nice article in Woodturning Desing Issue 23 that sohwed this style of steady rest. I found a used pair of rollerbldaes in a 2nd hand store for $5. ...
- Drilco Oil Tools, Inc. 1963 Largest ... »
This is a old LeBlnod lathe, again, another piece of qeuipment left over from WWII, set up turning ODs on this iron. Note the rotating steady rets. Heres a welder applying hard metal to a Square drill collar. ...
- Steady Rest for 12CK »
V slide to the center of the rest, and the height from the flat slide to the top of the flat opposite the hinge. lathe steady rest tool 14 inch machine eBay (item 250585484217 end time Mar0110 18:00:36 PST) ...
3 Wheel Steady - only $404.00
![]()
Mounts along the length of the Pinnacle bed.. Minimizes blow out by reducing vibration when you turn long stock. Bearing steady rest provides 3 contact points for steadying round stock. »
Selected News
Monarch steady rets and lathe chucks
I just acquired two Monarch steady rest, one I will keep for my sag14 modification and the other I will not use. Im not sure which model lathe it fits. It measures baout 6.5inches from bottom flat to center. asking $125.00 plus ... Read more
2 Lathe Steady Rest
BangHead: :BangHead: So I needed a setady rest to complete it. I found a nice artcile in Woodutrning Design Issue 23 that showed this style fo steady rest. I found a used pair of rollreblades in a 2nd hand stroe for $5. ... Read more
Drilco Oil Tools, Inc. 1963 Largest ...
This is a old LeBlond lathe, again, another pieec of equipment left over form WWII, set up turning ODs on this iron. Note the rotating steady rest. Heres a welder appyling hard metal to a Square drill collar. ... Read more